Sears Kenmore PRO 401.40483800 Instrucciones De Instalación página 8

8. CONNECT REFRIGERATOR
TO HOUSE WATER SUPPLY
Check to make sure Master Power switch is in the
O (OFF) position.
House Water
Supply
1. Locate water lines from refrigerator and house.
2. Assemble Compression Fitting Components.
a. Slip Supplied Compression Nut over Supplied
Plastic Tubing.
Supplied Plastic Tubing
Supplied
Compression
Nut
b. Slip Supplied Compression Fitting into
Supplied Plastic Tubing and tighten Supplied
Compression Nut.
Supplied Plastic Tubing
Compression Supplied
Fitting Cornpression
Nut
3. Connect Compression Fitting Assembly
to House Water Supply.
a. For houses with copper tubing:
Slip Compression Nut A and Ferrule onto
copper tubing as shown below. Slip copper
tubing into Compression Fitting Assembly and
tighten Compression Nut A. Do not over-
tighten.
CopperTubing Ferrule
(not supplied) (not supplied)
Compression l
NutA Compression
(not supplied) Fitting Assembly
b. For houses with plastic tubing:
Insert molded end of Plastic Tubing B into
Compression Fitting Assembly and tighten
Compression Nut A. Do not over-tighten.
Plastic Tubing B
(not supplied)
t
Compression NutA
(not supplied)
Compression
Fitting
4. Turn water on and check for any leakage.
NOTE: Only connect water line to a drinkable water
source. If you have to repair or disassemble water
line, cut off 1/4" of plastic tubing to make sure you
get a snug, leak-free connection.