Toyotomi Zibro LC-135 Instrucciones De Uso página 18

B
FILLING FUEL
ill the removable tank in a suitable place since there can al ays be some
spillage. ollo the procedure belo :
1 Make sure that the heater is switched off.
2 Open the upper lid and lift the removable tank out of the heater ( ig. B).
Put do n the removable tank (cap pointing up ards, handle on floor) and
scre off the fuel cap ( ig. C).
NOTE: Some drops may leak from the tank.
3 ill the removable tank using a fuel pump (refer to fuel pump operation
instructions.) Make sure that it is in a higher position than the removable tank
( ig. ). Insert the ribbed hose into the opening of the removable tank.
4 Check the removable tank fuel gauge
filling once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
5 Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
6 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C
SETTING THE CLOCK
It is only possible to set the correct time and day, when the heater is connected to
the mains and not burning. Use the adjustment keys
sion/day/set ( eekly timer)
irst press one of the three keys to s itch on the function (the -digit ¸ will start
blinking). Next, set the hours using the key (
key ( min.) and the day using the key e tension/day/set
Press once to increase the value by one step. When you hold do n the key, the
value ill continue going up, until you release the key again. After appro imately
10 seconds the -digit
minutes after switching off the heater, the information on the display will disap-
pear and the heater
!
When the heater has been unplugged for more than 30 minutes (or after a
power failure), the time and the day need to be set again.
D
WEEKLY TIMER
Here is an example on how the weekly timer can be programmed:
Monday
P1 ON 6:30
P1 OFF 8:45
P2 ON 12:00
P2 OFF 14:00
P3 ON 18:00
P3 OFF 23:00
• Maximum of 3 programs per day can be set.
• Every day of the week can be programmed separately.
• Minimum switching interval, 1 hour.
• Minimum activation time, 1 hour.
• Choice between manual and timer.
• Settings are saved in the memory and remain saved without power supply.
4
6
to set the day.
ill stop blinking and the setting
ill automatically s itch into the stand-by position.
Tuesday Wednesday Thursday
6:30 6:30 6:30
8:45 8:45 8:45
15:00 18:00 12:00
23:00 23:00 14:00
18:00
23:00
hile filling the tank ( ig. E). Stop
to set the time and exten-
hour) and the minutes using the
.
ill be locked ( ig. ). 5
Friday Saturday
6:30 10:00
8:45 23:00
12:00
14:00
18:00
23:00
empty
F: When the 4-digit
stops blinking, the set-
ting has been locked to
the indicated value.
Sunday
9:00
23:00
C
D
E
full