Labeling Channels
Channels can be labeled so that their calt letters appear whenever the channel is selected.
1.
Press the MENU button to display the menu.
Press the A or V buttons to select "Channel", then press the ENTER button.
Press the A or _r buttons to select "Name', then press the ENTER button,
Press the A or V buttons to select the channel to be assigned a new name_
then press the ENTER button.
Press the A or T buttons to select a letter_a number or a blank (Results in this
sequence: A...Z. 0...9. +, -, *,/. blank).
Press the _,, button to switch to the next field, which will be selected.
Select a second letter or digit by pressing the A or _' buttons, as above.
Repeat the process to select the last three digits. When you have finished,
press the ENTER button to assign the new name.
To erase the assigned new name_select "Clear" by pressing the 4 or _ button,
then press the ENTER button.
Press the EXIT button to exit.
_'-The names of digital broadcasting channels are automatically assigned and
thus cannot be assigned by users.
LNA (Low Noise Amplifier)
If the TV is operating in a weak-signal area, sometimes the LNA function can improve the reception (a low-noise preamplifier
boosts the incoming signal).
1.
Press the MENU button to display the menu.
Press the _, or T buttons to select "Channet'_ then press the ENTER button.
2.
Press the A or _" buttons to select "LNA', then press the ENTER
button.
3.
Press theft, or _' buttons to select 'On', then press the ENTER button.
Press the EXIT button to exit.
:_ LNA functions when the antenna is set to Air or Cable. Settings will be stored
separately in each channel. (See "Selecting the antenna." on page 28.)