R Digital Noise Reduction; Upgrading The Software - Samsung LN-T1953H Instrucciones Del Propietario

Digital Noise Reduction
If the broadcast signal received by your TV is weak, you can activate the Digital Noise Reduction feature to help reduce any static
and ghosting that may appear on the screen.
1. Press the MENU button to display the menu.
Press the ENTER button, to select "Picture".
2, Press the A or V button to select "Digital NR", then press the ENTER button.
3. Press the _, or • button to select "Off", "Low", "Medium", "High", "Auto".
Press the ENTER button.
Off: Turnsthe screennoisereductionfunctionoff.
Low: Reduces screennoiseat a lowlevel.
Medium: Reduces screennoiseat a mediumlevel.
_High: Reduces screennoiseat a high !eveL
"Auto: Automatically recognizesandreducesscreennoise.
Press the EXIT button to exit.
Upgrading the Software
Samsung may offer upgrades for your TV's firmware in the future. Please contact the Samsung calt center at 1-80O-SAMSUNG
(7267864) to receive information about downloading upgrades and using a USB drive. Upgrades will be possible by connecting a
USB drive to the USB port located on the back of your TV.
1. Insert a USB drive containing the firmware upgrade into the SERVICE prot
on the back of the TV.
2. Press the MENU button to display the menu.
Press the A or _r buttons to select "Setup", then press the ENTER button.
3. Press the _t, or T buttons to select SW Upgrade, then press the ENTER button.
4. Press the ENTER button.
The message Scanning for USB... It may take up to 30 seconds, is displayed.
Please be careful to not disconnect the power or remove the USB drive while
upgrades are being applied. The TV wilt shut off and turn on automatically after
completing the firmware upgrade. Please check the firmware version after the
upgrades are complete.
TV Rear Panel
k