Makita 9500D Manual De Instrucciones página 5

CAUTION:
• Never actuate the shaft lock when the spindle is
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch button actuates
properly.
• Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply press the switch button. Release
the switch button to stop. For continuous operation, press
the switch button fully, then release it. To stop the tool
from the locked position, press the switch button fully
again, then release it.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing flex wheel
WARNING:
• Always use supplied guard when flex wheel is on
tool. Wheel can shatter during use and guard helps
to reduce chances of personal injury.
1
2
3
4
001044
1. Switch button
1
001079
1. Screw
2. Outer flange
3. Flexible grind-
ing wheel
4. Pad
Mount the pad onto the spindle. Fit the wheel and outer
flange onto the spindle and temporarily secure with the
screw.
To tighten the screw, press the shaft lock firmly so that
the spindle cannot revolve, then use the hex wrench to
securely tighten the screw clockwise.
1
2
To remove the wheel, follow the installation procedure in
reverse.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
Sharpening with flexible grinding wheel
WARNING:
• It should never be necessary to force the tool.
Forcing and excessive pressure could cause
dangerous wheel breakage.
• ALWAYS replace wheel if tool is dropped while
grinding.
• NEVER bang or hit grinding disc or wheel onto
work.
5
001092
1. Hex wrench
2. Screw
3. Shaft lock
3
001118
1. Hex wrench
1
001132