ROSSMONT Waver Master WR-2CH Manual Del Usuario página 14

Ocultar thumbs Ver también para Waver Master WR-2CH:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
CAPACITIVE TOUCH BUTTON
The Waver unit is integrated with a safe capacitive touch button for some operations. By tapping and holding it, the
white LED in the center of the units flashes every second.
NOTE: It's important to keep the area of the button clean from dust or humidity which could compromise the
correct button responsiveness.
The next table shows all the functions:
TAP & HOLD TIME FUNCTION
2 sec
FISH FOOD
6 sec
MAINTENANCE
20 sec
HARD RESET
3 sec
SLAVE
(available only on
CONNECTION
WAVER SLAVE
RF-2CH)
Doc Rev. 2
Firmware Ver. 1.0.+
Software Ver. 1.0.+
INDEX
DESCRIPTION
It brings all the connected pumps (including those connected to all Waver
Slaves) at minimum level for the feed operation.
It's set for a standard duration of 5 minutes then the unit automatically
continues the program.
To manually exit this mode tap & hold again the capacitive button for 1
second.
Conceived for pumps maintenance. It interrupts the output current on
channels without shutting down the whole unit. While this function is active
it's possible to unplug the connected devices from the extension cables.
This function is operated only on the Waver unit where the capacitive touch
button is pressed
It resets the unit to factory default configuration. User and password are set
to:
USER: rossmont
PASSWORD: waver
Every slave connection is interrupted and the wifi connection mode is
brought to DIRECT ACCESS.
The device IP is set to 192.168.9.75
This function is available only when a MASTER unit is searching for a SLAVE
channel to add.
When clicking on ADD PRODUCT, the SLAVE search time will last for 15
seconds.
Once the registration is completed the SLAVE device will remain linked to
MASTER unit.
Pag. 14/71

Publicidad

Tabla de contenido
loading

Tabla de contenido