ROSSMONT Waver Master WR-2CH Manual Del Usuario página 6

PRODUCT SAFETY GUIDE
IMPORTANT: Prior to any operation you must verify the integrity of all parts of the product, especially the
•
cords and plug/sockets.
To prevent any accidental electric shock, make sure the product is positioned in a safe and dry place,
•
protected from water, humidity, calcium and/or salt deposits
Before using this product, check the data label on the bottom of the product and verify that the operating
•
voltage corresponds to your Mains voltage
The product is intended for internal use only
•
Do not install near any heat sources such as radiators, heat register, stoves, or other apparatus that produces
•
heat
It's possible to use the device at a temperature not higher than 35°C/95°F
•
This device is compatible with Rossmont products only
•
This device is intended for use as an aquarium equipment only.
•
Do not connect any device which is not specifically intended for use with Waver otherwise the warranty is
•
voided.
Do not attempt to power another Waver unit connecting it to the product cord extensions sockets
•
Clean only with dry cloth
•
Unplug any electrical appliance connected to your aquarium before putting your hands in water.
•
It's strongly recommended the wall socket is positioned at a higher level than the tank to prevent the risk of
•
water damages to electrical system. If this is not possible, verify the lowest part of the cable is lower than the
wall socket position: DRIP LOOP.
In case the plug/socket were wet, please disconnect the general switch
•
Do not lift the product by the cord. Disconnect and connect the unit only by grasping the plug.
•
It's necessary to power the product through a residual current circuit-breaker system with a rated current not
•
exceeding 30mA
Do not connect the appliance if the power cord or one of the extension cables is frayed or damaged. In this
•
case it's necessary to replace the entire unit without trying to repair it
The product is not intended for use by people with reduced sensory, physical or mental, unless they are close
•
supervised and instructed by a person responsible for their safety. The controller is not a toy: do not allow
children to play with it
This guide will give you instructions for Waver device only. For Mover pumps or any other Rossmont product
•
please refer to the dedicated instruction manual
MAINTENANCE
The product doesn't require any particular maintenance but it's important to keep surfaces clean especially from
humidity or dust deposits which could influence the correct operation of the capacitive touch button.
To keep the surfaces clean, it's enough to pass a soft dry cloth.
Do not use any kind of solvent or abrasive paper.
It's recommended to clean the surface/environment where the product is positioned.
Doc Rev. 2
Firmware Ver. 1.0.+
Software Ver. 1.0.+
INDEX
Pag. 6/71