Firmware Ver. 1.0.+
Software Ver. 1.0.+
INDEX
FCC COMPLIANCE STATEMENTS
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. this device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. (FCC § 15.21 -Information to user)
(FCC§ 15.105 Information to the user statements)
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE CONDITIONS
The user is cautioned to maintain a minimum distance of 20cm (8 inch) from the product to ensure compliance with RF
exposure requirements.
FCC Details
Applicant: Rossmont Srl
Model: Waver Master WR-2CH
Contains FCC ID: 2AGQLCWVU01A and FCC ID: 2AGQLCWVU01
Model: Waver Slave RF-2CH
Contains FCC ID: 2AGQLCWVU01
Doc Rev. 2
Pag. 3/71