Vehicle Selection; Erase Codes; Mil Status - OTC 3208 Guia Del Usuario

en

Vehicle Selection

Vehicle Selection will be dis-
played for Read Codes when a
manufacturer specific DTC is
retrieved from the vehicle .

Erase Codes

The Erase function performs
the following:
9 Erases codes (both
Confirmed and Pending
DTCs) when erasing OBDII/
EOBD codes . Permanent
codes can only be erased by
the vehicle .
9 May erase Freeze Data results
depending on the vehcle .
9 Sets I / M Monitors to
not ready .
NOTICE
Perform Erase Codes
function only after
systems have been
checked completely
and DTCs have been
written down .
To erase codes from the vehi-
cle computer:
1 . Set the ignition to Key On
Engine Off . Do NOT start the
vehicle . The engine should
not be running .
2 . Press and hold the ERASE
key for 3 seconds then
Bosch Automotive Service Solutions Inc.
| OTC3208 | Operating instructions | 7
release, or select Erase
Codes from Diagnostic Menu;
press  ENTER .
3 . When the confirmation mes-
sage appears on the display,
choose one of the follow-
ing options .
• To proceed with the opera-
tion: Press  ENTER for YES .
• To cancel the operation and
return to the Diagnostic
Menu: Press  B ACK for NO .
4 . If ABS is supported for your
vehicle, a menu is shown to
select either OBDII/EOBD,
or ABS . Select ABS to erase
ABS codes, and OBDII/EOBD
to erase emissions related
powertrain codes .
The Tool will automatically per-
form the Read Codes function
after erasing codes . The Tool
will then indicate the number of
codes remaining .
NOTICE
If after erasing codes
a DTC returns, the
problem has not been
fixed or other faults
are present .

MIL Status

MIL (Malfunction Indicator
Lamp) status indicates if the
575512 REV B | 03.2016