Accessories; Cleaning Instructions - DeVilbiss Healthcare SmartLink DV5M Guía De Instrucciones

Message shown if an error is encountered while updating device settings. This
message will remain on the display until acknowledged by pressing any key
on the keypad or a 15 minute timeout occurs. NOTE–If this message is
displayed, contact your clinician.
Message shown after removing the card from the module. This message will
remain on the display for ten seconds.
Message shown when a new module with mismatched data is detected.
This message will remain on the display until the module is removed.
Contact your provider to notify them of the situation and for instructions on
how to resolve the issue. If this situation is not resolved, the module will not
be able to record usage and therapy data. However, although this message will remain on the display with the
module attached, the CPAP will still be functional and provide therapy.
other Messages
In the unlikely event that a fault should occur, this message will be shown
when a module fault condition is encountered (Clock Error, Memory Error,
Setting Error, etc).
Message shown when firmware is being updated. This message will remain
on the display until the update is complete. Occasionally a firmware update
may be provided for your device via SmartLink Data Card. The firmware
update process is automatic and may take a few seconds to complete. Once
the update is complete, the system will return to normal operation.

accESSoRiES

Oximeter Kit ........................................................................................................................................... DV5M-697
Oximeter Finger Clip Sensor ...................................................................................................................... 8000AA
Oximeter Ear Clip Sensor ............................................................................................................................8000Q
Oximeter Finger Soft Sensor, Medium ...................................................................................................... 8000SM
Oximeter Finger Soft Sensor, Large ........................................................................................................... 8000SL

clEaNiNg iNStRuctioNS

WaRNiNg
To avoid electric shock, always unplug power cord from the wall outlet power source.
CAUTION-Never rinse or place the device in water. Never allow liquids to get into or around any of the ports
or openings; doing so will result in product damage. If this occurs, do not use the device. Contact your provider
for service.
NOTE–The module should be cleaned as needed.
1. Turn off the CPAP and unplug it from the power source.
2. Use a soft damp cloth to clean the surfaces of the device.
3. Allow the device to dry completely before plugging it into a power source.
EN - 8
Setting Error
Contact Provider
Card Removed
Send to Provider
Setup Required
Contact Provider
E00 Module Fault
Contact Provider
Firmware Update
Please Wait . . .
A-DV5M-1