Spare Parts - Heiniger Xperience/D Manual De Instrucciones

Malfunction
Clipper is cutting
poorly or not at all.
Motor unit heats up.

8 Spare parts

See spare parts list at the end of these operating instructions.
Incorrect or defective spare parts can lead to damage, malfunction and complete
failure and can jeopardise safety.
► Use only original spare parts from the manufacturer. Obtain spare parts from an
authorised dealer or directly from the manufacturer.
► If non-approved parts are used, all warranty, service, compensation and liability
claims against the manufacturer or its employees, dealers and representatives will be
forfeited.
34
Possible cause
Cutting blades are dull.
Clipping blades are not
properly sharpened.
Clipping blades are not
lubricated.
Clipping pressure too low.
Leaf springs have broken.
The animal's hair is too wet.
Hairs are stuck between upper
and lower blade.
Clipping head has too much
play.
Clipping blades are not
properly aligned.
Air filter clogged.
Clipping pressure too high.
Defective bearing.
CAUTION
NOTE
Corrective measure
Notify customer service.
Lubricate the clipping blades
every 15 minutes.
Increase the clipping pressure
by turning the adjusting knob as
described in chapter 6.2.
Notify customer service.
Only clip dry hair.
Remove the clipping blades;
clean, lubricate and install them
again; set the clipping pressure.
Notify customer service.
Align the clipping blades
correctly, see Fig. 9.
Clean or replace the air filter.
Reduce the clipping pressure.
Notify customer service.
Cattle clipper Xperience