Troubleshooting; Safety Information; Causes Of Malfunctions And Their Rectification - Heiniger Xperience/D Manual De Instrucciones

7 Troubleshooting

7.1 Safety information

Mortal danger from electrical current!
Mortal danger can result from contact with current-carrying conductors or components!
► Pull the plug from the socket before you start troubleshooting.
► Repairs to electrical devices must only be carried out by the factory service
department or specialists who have been trained by the manufacturer.

7.2 Causes of malfunctions and their rectification

Malfunction
Upper blades moving
too little.
Upper blade does not
move.
Adjusting knob is
jammed.
Leaf springs in the
head mount are too
loose.
Play between
swivelling lever and
leaf spring.
Swivelling lever is
difficult to move up
and down.
Motor not running.
Motor runs very slowly. Clipping blades not lubricated
Cattle clipper Xperience
DANGER
Possible cause
Leaf springs have broken.
Square end of eccentric
shaft or eccentric shaft worn
(insufficient lubrication).
Defective gear.
Thread is dirty or rusty.
Pressure spring is jammed.
Comb plate screws are loose.
Leaf springs and/or cylinder
head screws are worn.
Centring sleeve lost.
Burnt smell emanating from
the motor housing; motor
burnt.
Motor and/or electronics
defective.
adequately.
Motor and/or electronics
defective.
Corrective measure
Notify customer service.
Notify customer service.
Notify customer service.
Tighten the comb plate screws.
Notify customer service.
Notify customer service.
Notify customer service.
Notify customer service.
Lubricate the clipping blades.
Notify customer service.
33