Spare Parts - Heiniger Opal Traducción Del Manual Original

Malfunction
The control light of
the charging station
in not on
When the battery is
flat the light of the
charging station
does not change
from green to red
8

Spare parts

See illustration spare parts at the end of this instruction manual.
WARNING!
Faulty spare parts may cause damages, malfunctions or total loss and may
reduce security. Therefore:
Only use original spare parts from the manufacturer. Purchase the spare
X
parts at the official distributor or directly at the manufacturer.
If using no original spare parts all warranty and service claims are expi-
X
ring.
Pos. No. Description
1 Top housing shell, complete
2 Bottom housing shell, complete
3 Battery
4 Motor complete
5 Front motor holder
6 Rear motor holder
7 PCB clipper
8 Turning lever
9 Rubber tap
10 Seal
11 Kombitorx KA30x16 PT screw
12 Kombitorx KA30x8 PT-screw
22 Blade support
23 Blade interlock
24 Clipping pressure spring
25 Blade guide
Translation of the original instructions / Small animal clipper
Cause
Charging station is not
connected to the power
supply
Charging station is faulty Have charging station inspected
Contacts of battery and/
or charging station are
dirty
Faulty battery
Battery exhausted
Contacts of the charging
station are deformed
Rectification
Connect the charging station to
the power supply
(S)
Clean contacts
Replace battery
Place the battery in the charging
station for at least 20 minutes.
Replace the battery if the char-
ging process fails to start.
Have the charging station re-
paired (S)
Quantity
1x
1x
1x
1x
1x
1x
1x
1x
1x
1x
12x
1x
1x
1x
1x
1x
19