TRAPP TRR 180 Manual De Instrucciones página 59

www.trapp.com.br
Feeding funnel assembly
1
6
5
7
Position the feeding funnel (1) into
 
the body (2);
Fix the hinge shaft (3) at the hinge of the feed
 
funnel (1) and body (2) then lock the hinge
shaft (3) with the retaining ring (4);
To close (lock) the feed funnel (1), fit the
 
pressure washer (5), flat washer (6) and
locking handle (7) in the body (2).
Attaching to tractor
Carefully read Operator's Manual, tractor and
cardan instructions manuals. Shredder TRR 280
has been manufactured to be coupled to a tractor
equipped with a hydraulic lift of three universal
connecting points, as shown below.
Installation
 
 
3
2
 
 
4
After that, make sure all machine screws and
nuts are properly tightened (see table "Torque
Specifications").
Pay attention to tractor front wheels. When
shredder is lifted, and the wheels seem to light,
place ballast on the front part of the tractor.
Before connecting the equipment to the
tractor, place both on flat ground and make
sure nobody stands between them.
Slowly approach shredder to the lift arms.
First, connect the lower arms and then the
upper arm. The shredder is equipped with
category I securing pins.
Make sure pins are secured to the
corresponding safety lock.
Block lift arms with respective chain or anti-
vibration stretchers.
59