Useful Suggestions - TRAPP TRR 180 Manual De Instrucciones

www.trapp.com.br
Maintenance motor a gasoline
In the first 5 hours
Change the oil of the crankcase
O 
Every hours or daily
8
Check the oil level
O 
Clean the area around the muffler and the controls
O 
Clean the protective screen
O 
Every hours
25 or annually
Clean the air filter*
O 
Clean the pre-purifier*
O 
Every hours
50 or annually
Change the engine oil
O 
Check the muffler and spark arrester
O 
Annually
Replace the oil filter
O 
Replace the pre-purifier
O 
Replace the spark plug
O 
Replace the fuel filter
O 
Clean the air cooling system*
O 
* In very dusty places or when particles brought by the air are present, clean more frequently.
Some problems may occur during the use of the shredder. Find some suggestions to solve them below:
Problem Probable Cause
Shredder Excessive intake/feeding. Organic
jamming material accumulates inside the
machine.
Low production 1. Insufficient feeding.
2. Machine revolution below
specification.
3. Humid product.
Irregular cut 1. Cutting blades need sharpening.
2. Worn counter cutting blade.

Useful Suggestions

Solution
Turn shredder off. Remove upper output device,
open cover, remove excess of material from inside
the machine. Close cover, replace output device,
turn shredder on, wait for motor to reach maximum
revolution and get back to work. Control machine
intake/feeding.
1. Maintain continuous feeding, yet not overfeeding
which may cause shredder to jam.
2. Check whether TDP rpm is below 540 rpm.
3. Shred dry material only; humid products may block
output device.
1. Sharpen cutting blades as indicated in "Sharpen
and Replace Blades".
2. Do as item "Check Blades".
69