Optika XDS-3 MET Manual De Instrucciones página 11

3.0 UnPACKInG And ASSEMBLY
In the box there is also a blue filter, that you can insert in the same slot of the polarizer.
Connecting the power cable
Connect the cable from the back of the microscope to the lamp housing:
Turn the main switch (4) to "0"(off) before connecting the power cable.
Insert the plug into the power jack () of the microscope.
Plug the power cable into the mains socket. Check for a safe connection.
Please use the supplied power cable. If lost or damaged, please refer to qualified service.
Connect the power cable to a grounded (earthed) power supply only.
Connect the mains plug into the socket at the base
Make sure, before you turn the illumination on, that the voltage selector is set to the mains voltage for
your region.
The power cord should be used only on network sockets equipped with adequate grounding.
Contact a technician to check the state of your electrical system. If there is no need to install additional
accessories, the instrument is now ready for use. Once positioned and installed with the necessary
components, the microscope is ready to be used. your microscope is a laboratory instrument desi-
gned to last. Handle it always carefully and avoid abrupt vibrations or shocks. Always disconnect the
power cable from the microscope when not in use for long time, while you clean it or when you perform
any maintenance.
AVOId dISASSEMBLInG THE InSTRUMEnT
Do not disassemble the instrument. This entails the cancellation of the warranty and may cause
malfunction.
CABLE TO THE LAMP
HOuSIng
Page 11