Trouble Shooting - FujiFilm INSTAX SHARE SP-3 Manual De Instrucciones

TROUBLE SHOOTING

During printing
EN
Problems
The printer cannot be
turned on.
You entered the
password, but the device
cannot be connected to
the printer.
You pressed the
REPRINT button, but
you cannot print.
16
instax_BO-C_6lang.indb 16 instax_BO-C_6lang.indb 16
Possible Causes
1 The battery power is low. (The
remaining battery LED is flashing
red.)
2 The battery is not inserted correctly.
3 You did not press the POWER
button for long enough.
● The password is incorrect.
1 No images are stored in the printer.
(The remaining film LED flashes for
3 seconds.)
2 No film remains in the printer. (All the
remaining film LEDs are flashing.)
3 The film pack is not loaded. (All the
remaining film LEDs are flashing.)
Solutions
1 Charge the battery fully.
2 Insert the battery correctly.
3 Press and hold the POWER button for approx. 1
second.
● Turn the printer on while holding the REPRINT
button to reset the password to the factory
default (1111).
1 Transmit an image to print.
2 Load a new film pack.
3 Load a new film pack.
2017/9/14 15:21:13 2017/9/14 15:21:13