Deactivating The Shock Warning Function - Hilti PR 30-HVS Manual De Instrucciones

7.3.7 Menu options 6
1. Press and hold the on/off button for two seconds when switching the laser receiver on.
The menu then appears in the display.
2. Use the "Units" button to select metric or imperial measuring units.
3. Use the "Volume" button to assign the more rapid signal tone to the detection area above or below the marking
notch.
4. Use the arrow buttons (Left / Right) to select further points as necessary.
NOTE The arrow buttons (Left / Right) can be used to select settings. The "Units" button is used to change the
applicable settings. The following settings can be made: Display software version (no adjustment possible), PR
30-HVS sleep mode (off / on), units for inclined plane mode (%/°), pairing the PR 30-HVS (pair / separate), pairing
the PRA 90 (pair / separate), sensitivity of shock warning function (high / medium / low), wireless connection (on
/ off). Settings that affect the rotating laser only become effective when the rotating laser is switched on and a
wireless connection has been established.
5. To save the settings, switch the laser receiver off.
NOTE Each setting that has been made becomes effective the next time the tool is switched on.
7.3.8 Double-click
When operating the tool, the "automatic alignment" and "surveillance" commands must be confirmed with a double-
click in order to avoid incorrect operation.

7.4 Deactivating the shock warning function

1. Switch the tool on (see 7.2).
2. Press the "Deactivate shock warning" button.
The shock warning deactivation LED lights con-
stantly, indicating that the function has been deac-
tivated.
3. To return to standard operating mode, switch the
tool off and then switch it back on again.
en
33