Manual Scan Line Function; Automatic Scan Line Function; Deactivating The Shock Warning Function - Hilti PR 30-HVSG A12 Manual De Instrucciones

3. Press the
button on the rotating laser.
▶ The inclined plane mode LED on the rotating laser lights constantly.
▶ The inclined plane mode symbol is shown on the PRA 30G laser receiver.
4. Position the marking notch on the PRA 30G laser receiver at the other edge of the inclined plane.
5. Begin automatic alignment by double-clicking the
corresponding function in the AUTO menu.
▶ The rotating laser inclines the laser plane on the X-axis automatically until the mark at the PRA 30G
laser receiver is reached. An signal tone is emitted by the laser receiver repeatedly during this
procedure.
▶ The rotating laser levels itself on the Y-axis once the position has been reached. Successful
completion is indicated by a continuous signal tone with a duration of 5 seconds. The
symbol is displayed briefly.
▶ If automatic alignment cannot be completed successfully, short signal tones are emitted and the
is displayed briefly.
6. Stop automatic inclination before completion by double-clicking the
receiver.
If the rotating laser begins the automatic search in the wrong direction, press the
change the search direction.
5.13

Manual scan line function

1. Press the
button on the rotating laser.
2. Adjust the laser plane to the desired position / height. The scan line function can be used in horizontal,
vertical and inclined plane mode.
3. Press the
button on the PRA 30G to display the menu.
4. Select the manual scan line function
5. The width of the scan line can be set to one of four widths via the scan line width submenu.
6. After selecting the scan line function in the menu, the
line to the left or right. The laser receiver does not require to be within the path of laser beam in order to
do this.
5.14

Automatic scan line function

1. Press the
button on the rotating laser.
2. Adjust the laser plane to the desired position / height. The scan line function can be used in horizontal,
vertical and inclined plane mode.
3. Press the
button on the PRA 30G to display the AUTO menu.
4. Start the automatic scan line function
5. Bring the laser receiver into the desired position. The rotating laser automatically concentrates the beam
along a shortened line in the area of the laser receiver.
The width of the scan line can be adjusted using menu on the PRA 30G. The narrower the scan
line is set, the brighter it will appear.
6. After selecting the scan line function in the menu, the
line to the left or right. The laser receiver does not require to be within the path of laser beam in order to
do this.
5.15

Deactivating the shock warning function

1. Press the button on the rotating laser.
2. Press the
button.
▶ The shock warning deactivation LED lights constantly, indicating that the function has been
deactivated.
To return to standard operating mode, switch the rotating laser off and then switch it back on again.
*2179602*
button on the PRA 30G laser receiver or select the
.
.
2179602
button on the PRA 30G laser
and symbols can be used to shift the laser
and symbols can be used to shift the laser
button to
English 33