Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation inside the wall cupboard
Attaching a handle:
❑ A handle must be attached to the
filter drawer.
❑ This handle can either be a wooden strip
that matches the kitchen
cupboards or a the handle that is
available as an optional accessory (see
section on optional accessories in the
user instructions).
1. Mark two points on the handle with the
O
enclosed template
and make holes
III
with a bradawl.
If the holes are drilled:
l 2 mm – max. 10 mm deep.
14,5
2. Align the handle and screw onto the
appliance with the two enclosed
screws.
16
3. Insert the filter frames (see Operating
Manual).
Note: The extractor hood housing inside
the wall cupboard can be boarded up (e.g.
with chipboard).
Please observe the following:
– The shelf must not be rest upon the
extractor hood housing.
– The board at the front should not be
attached to the housing.
– Provide access for customer service.
Removal:
The extractor hood is removed in reverse
sequence.
Note: In circulating-air mode the activated
carbon filter and plastic holder must be
removed in order to gain access to the
mounting screws and installation aids.
Weight in kg:
Exhaust air
Re-circulating air
9,5
The manufacturer reserves the right to make design
alterations in the interests of technical development.
10,5
Publicidad
Tabla de contenido
