Connecting The Video System - Dometic PerfectView CAM360AHD Instrucciones De Montaje

Connecting the video system

8 Connecting the video system
A
NOTICE! Damage hazard
• The lines for terminal 15, left indicator, right indicator and reverse
must be secured on the vehicle side with a fuse rated no higher than
3 A. If this is not the case, then an additional fuse must be used at the
corresponding consumer point.
• If the connection
be insulated. The load of this output must not exceed 150 mA.
I
NOTE
Lay the camera cable so that, should you need to remove the camera,
you can access the plug connection between the camera and the exten-
sion cable easily.
➤ Connect the video system as shown in the connection diagram (fig. e, page 8).
➤ Insulate the plug of the camera adapter cable with the included vulcanising
adhesive tape (fig. 9, page 6).
Key to the connection diagram
No. in
fig. e,
Description of the connection
page 8
1 Monitor
2 Cameras
3 Controller
4 USB input
5 Black plug (jack type): Infrared receiver for the remote control
6 Yellow plug: Video output
7 Black plug ("FRONT"): Front camera
8 Black plug ("LEFT"): Left camera
9 Black plug ("RIGHT"): Right camera
10 Black plug ("REAR"): Rear camera
bk Black cable ("GND"): Connection to earth (terminal 31)
26
"MONITOR CTRL OUT" is not used, the copper end must
CAM360AHD
EN