Dometic PerfectView CAM360AHD Instrucciones De Montaje página 36

Video system settings
If you detect an offset in the rear measuring tape (fig. r, page 13):
➤ Change the "LENGTH" parameter.
➤ Select "CALIBRATION".
➤ Check the image.
➤ Repeat these steps until no offset is visible.
After fine adjustment:
➤ Select "SAVE EXTERN" to also save the configuration including calibration to an
external storage device (flash drive).
9.5 Setting a SINGLE CAMERA
SINGLE CAMERA
BACK
CAMERA
OFFSET H
OFFSET V
ZOOM H
ZOOM V
DIST LINE
SAVE
Setting
CAMERA
OFFSET H
OFFSET V
ZOOM H
36
0
0
1.0
1.0
ON
Description
"FRONT", "RIGHT", "REAR", "LEFT"
Move camera image left or right
Move camera image up or down
Zoom camera image out
CAM360AHD
EN