Warnings And Error Messages; Warnings; Error Messages - Nedo PRIMUS 2 H Manual De Instrucciones

EN Operating Instructions

9 Warnings and error messages

9.1

Warnings

Warnings always indicate particular or special operating circumstances. The
red LED of the display panel and the warning symbol
with the display of the warning.
To reset the warning, use the
On again or use the
Display
C00
C01
C02
C03
9.2

Error messages

Display
ERR1 – ERR11
ERR12
button to switch the laser Off and then back
button to switch to MANUAL operating mode.
Description of the warning
Laser is tilted by more than ±5° and cannot horizontally level itself.
TILT alarm, vertical/height error. The laser was moved after 30 seconds had
expired following levelling.
Time exceeded during automatic levelling.
Unallowed change in horizontal position
Description of the error message
Internal unit error Send laser to NEDO's Service department.

If this error occurs more than once,
department.

in the display flash
vertical position.
 
Send laser to NEDO's Service

27