Setting The Time Zone; Temperature Display; Setting The Alarm Time; Activating/Deactivating The Alarm - Hama RC 750 Instrucciones De Uso

Setting the time zone

Note – Time zone
• The DCF signal can be received over long distances, but always transmits the current Central European
Time in Germany. Make sure you account for the time difference in countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in Germany. This means that you should set +3 for
the time zone. The clock then automatically sets the time to 3 hours after the DCF signal received or
relative to the manually set time.
• Press and hold the
• Press and hold the mode button (4) for approx. 3 seconds to set the required time zone difference.
• To select the individual values, press the
pressing the mode button (4).
• Press and hold the
time.
Selecting 12 or 24-hour format
• Press the button (5) to switch between the 12 and 24-hour formats.

5.3. Temperature display

• Press the wave °C/°F button (3) to choose between °C and °F for the temperature display.
5.4. Alarm
Note – Alarm
The alarm time always depends on the time displayed, that is, the local or time zone-shifted time (

Setting the alarm time

• Repeatedly press the mode button (4) to access alarm mode 1 (AL1) or 2 (AL2).
• Press and hold the mode button (4) to set the alarm time for the alarm displayed. The hours display begins
to flash.
• Press the button (5) or the
by pressing the mode button (4). The minutes display begins to flash.
• Repeat the process to set the minutes for the alarm time.
• Press the mode button (4) repeatedly to also set the other alarm mode or return to the temperature display.

Activating/deactivating the alarm

• Press the alarm (2) repeatedly to activate/deactivate alarm 1 or alarm 2.
• If an alarm is activated, the corresponding symbol
6
button (5) for approx. 3 seconds until the time zone symbol
button (5) for 3 seconds to switch the display between local and time zone-shifted
button (6) to select the hour for the alarm time and confirm your selection
button (5) or the button (6) and confirm each selection by
/ will be displayed.
1
2
is displayed.
F
).
F