Black and Decker BCD701 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Trigger Switch & Reversing Button (Fig. I)
The drill is turned ON and OFF by squeezing and
releasing the trigger switch 
depressed, the higher the speed of the drill.
A forward/reverse control button 
direction of the tool and also serves as a lock off button.
To select forward rotation, release the trigger switch and
depress the forward/reverse control button to the left.
To select reverse, depress the forward/reverse control
button the opposite direction.
NOTE: The center position of the control button locks the
tool in the off position.
When changing the position of the control button, be
sure the trigger is released.
nOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should
be avoided.
Fig. I
1
Torque Control (Fig. J)
This tool is fitted with a torque adjustment collar 
the operating mode and to set the torque for tightening
screws. Large screws and hard workpiece materials
require a higher torque setting than small screws and soft
workpiece materials.
For drilling in wood, metal and plastics, set the collar to
the drilling position symbol
For screwdriving, set the collar to the desired setting. If
you do not yet know the appropriate setting, proceed
as follows:
-
Set the collar to the lowest torque setting.
-
Tighten the first screw.
-
If the clutch ratchets before the desired result
is achieved, increase the collar setting and
continue tightening the screw. Repeat until you
reach the correct setting. Use this setting for the
remaining screws.
Fig. J
3
8
. The farther the trigger is
 1 
determines the
 2 
2
 3 
to select
Keyless Chuck (Fig. K)

WARNING: Make certain the battery pack is
removed to prevent tool actuation before installing or
removing accessories.
To insert a drill bit or other accessory:
1. Grasp the rear half of the chuck 
and use your other hand to rotate the front half in
the counterclockwise direction, as viewed from the
chuck end. This will open the jaws of the chuck to allow
insertion of the bit or accessory
2. Insert the bit or other accessory fully into the chuck, and
tighten securely by holding the rear half of the chuck
and rotating the front portion in the clockwise direction
as viewed from the chuck end.

WARNING: Do not attempt to tighten drill bits
(or any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to
the chuck and personal injury may occur when
changing accessories.
Fig. K
4
Screw Driving
For driving fasteners, the reversing button should be
pushed to the left. Use reverse (button pushed to the right)
for removing fasteners. When moving from forward to
reverse, or vice versa, always release the trigger switch first.
(Fig. A, L)
LED Work Light
When drill is activated by pulling the trigger switch 
integrated LED work light 
the work area. Do not use LED work light as flashlight.
Fig. L
5
Drilling

WARNING: Drill may stall if overloaded causing a
sudden twist. Always expect the stall. Grip the drill
firmly to control the twisting action and avoid injury.
Use sharp drill bits only.
Support and secure work properly, as instructed in the
Safety Instructions.
 4 
with one hand
 5 
will automatically illuminate
 1 
, the

Publicidad

Tabla de contenido
loading

Tabla de contenido