Switching On And Off - Black and Decker BCD701 Manual De Instrucciones

English
Proper Hand Position (Fig. H)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand positionx as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle .
2
nOTE: Do not rest fingers on sanding base during use.
Move the sander in long sweeping strokes across the
surface, letting the tool do the work. Light pressure is
all that is required for sanding, polishing or scrubbing.
Excessive pressure will slow the tool and produce inferior
results. Check your work often, product is capable of
removing material rapidly.
Fig. H

WARNING: Shock hazard. Under no circumstances
should this product be used near water.

CAUTION: To reduce the risk of injury, turn off and
remove the battery from the tool before making any
adjustments or removing or installing attachments
or accessories.

Switching On and Off

1. To switch the tool "ON", depress the on/off switch
the side position I.
2. To switch the tool "OFF", depress the on/off switch
the side position O.
Fitting Sanding Sheet (Fig. I)

WARNING: Remove battery when removing or
installing the sanding sheet.
1. Hold the tool with the sanding base facing upwards.
2. Place the sanding sheet
the grit facing up.
8
2
onto the sanding base with
12
Fig. I
12
Rotating the Sanding Base (Fig. J)

WARNING: Remove battery when removing or
installing the sanding base.
The sanding base
becomes worn.
1. Hold the tool with the sanding base facing upwards.
2. Unscrew the screw that holds the sanding base to
the sander.
3. Rotate the sanding base so that an unworn corner faces
forward. Make sure the sanding base is properly seated.
4. Secure the sanding base by inserting and tightening
the screw.
Fig. J
3
1 at
1 at
Hints for optimum use

WARNING: Let the tool work at its own pace. Do
not overload.
• Do not place your hands over the ventilation slots.
• Do not exert too much pressure on the tool.
can be rotated if a corner
3