Black and Decker BCD701 Manual De Instrucciones página 78

English
USB Power Port
The BLACK+DECKER GoPak 2 in 1 battery is equipped with a
USB Type A power port. It delivers up to 2.4 amp total current.
nOTE: The current delivered to device is dependent on user
device and user's chosen cable.

WARNING: Ensure the terminal cap is securly
attached to the BLACK+DECKER GoPak 2 in 1 battery
when using it to power/charge your device.
• Install terminal cap on the tool terminals.
• Device charging from USB will start automatically when
device is connected.
• To turn OFF, disconnect USB device.
Proper Hand Position (Fig. I)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
and one hand on the auxiliary handle.
Fig. I
Switching On and Off (Fig. A, J)
This tool is equipped with a lock-off button
button must be disengaged for the jig saw to turn on. To
disengage the button, depress the button on the side of the
handle that shows the unlock symbol.
Fig. J
• To switch the tool on, press the variable speed switch
The tool speed depends on how far you depress
the switch.
• To switch the tool off, release the variable speed switch.
8
. The
2
2
1 .
How to Use the Sightline
1. Use a pencil to mark the cutting line.
2. Position the jig saw over the line
3. Viewing from directly above the jig saw, the line of cut
can be easily followed.
Fig. K
Hints for optimum use
General
Use a high speed for wood, a medium speed for
aluminum and PVC and a low speed for metals other then
aluminum Specific materials also require specialty blades
(sold separately).
Sawing laminates
As the saw blade cuts on the upward stroke, splintering may
occur on the surface closest to the shoe plate.
• Use a fine-tooth saw blade.
• Saw from the back surface of the workpiece.
• To minimize splintering, clamp a piece of scrap wood
or hardboard to both sides of the workpiece and saw
through this sandwich.
Sawing metal
• Be aware that sawing metal takes much more time than
sawing wood.
• Use a saw blade suitable for sawing metal.
• When cutting thin metal, clamp a piece of scrap wood
to the back surface of the workpiece and cut through
this sandwich.
• Spread a film of oil along the intended line of cut.
Pocket Cutting (Fig. L)
A pocket cut is an easy method of making an inside cut. The
saw can be inserted directly into a panel or board without
first drilling a lead or pilot hole. In pocket cutting, measure
the surface to be cut and mark clearly with a pencil. Next tip
the saw forward until the front end of the shoe sits firmly
on the work surface and the blade clears the work through
its full stroke. Switch the tool on and allow it to attain
maximum speed. Grip the saw firmly and lower the back
edge of tool slowly until the shoe sits flate on the surface.
Hold the shoe flat against the wood and continue cutting.
Do not remove blade from cut while it is still moving. Blade
must come to a complete stop.
Feature (Fig. K)
®
.
15
15