Black and Decker BCD701 Manual De Instrucciones página 116

English
Accessories

WARNING: Since accessories, other than those
offered by BLACK+DECKER have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact BLACK+DECKER, call
1-800-544-6986.
item Description
240 grit sanding mesh
For finishing and detail sanding
120 grit sanding mesh
For a medium finish for large detail sanding.
80 grit sanding mesh
For a coarse finish for large detail sanding.
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest
you or call the BLACK+DECKER help line at 1-800-544-6986.
Problem
Unit will not start.
Battery will not charge.
Unit shuts off abruptly.
10
TROUBLESHOOTING
Possible Cause
Battery not installed properly.
Battery not charged.
Internal components too hot.
Cables not properly connected.
Battery not plugged in.
Surrounding air temperature too hot or too cold.
Battery has reached its maximum thermal limit.
Out of charge. (To maximize the life of the
battery it is designed to shutoff abruptly
when the charge is depleted.)
Possible solution
Check battery installation.
Check battery charging requirements.
Allow tool to cool down.
Check the cable connections to the battery.
Check the connections between the battery,
the device used to charge the battery and the
working outlet.
Move battery to a surrounding air temperature
of above 40 °F (4.5 °C) or below 105 °F
(+40.5 °C).
Allow battery pack to cool down.
Remove battery and charge.