Set-Up - Tribest Sedona SD-P9000 Manual De Instrucciones

seT-uP

Function of switch and buttons:
1. POWER switch turns the Sedona on and off.
2. °F/°C button will enable you to select a temperature display mode (Celsius or Fahrenheit). Select
which temperature mode you want to display by pressing °F/°C button. The default setting of
Sedona is Celsius when out of the factory. Once you set the machine to Celsius or Fahrenheit,
the Sedona will remember your setting even after you turn OFF the machine.
3. Temp window is used for two separate functions.
Please note that during operation, the Temperature Display will display the selected temperature
setting, and NOT of the actual temperature of the drying compartment.
A. Setting Desired Temperature (Set-Up)- During set up this window will be used to set
the desired temperature of the drying compartment.
a. The temperature selected is the maximum temperature that the drying com-
b. The temperature of the drying compartment is regulated by a thermal sensor.
B. Temperature Display- Will display your selected temperature setting
a. The 2 icons on the far left of the TEMP display indicate which of
b. When the top left icon is lit, the top heating coil is active.
c. When the bottom left icon is lit, the lower heating coil is active.
d. When the two icons light up alternately, both heating coils are active.
4. TIMER window shows the selected amount of hours during set-up of the Sedona. It also shows
the remaining amount of time during operation.
More Tips:
• When the dot located right next to the lower portion of the time display is blinking, the
timer is on and the machine is working.
• If the dot is not lit, the timer has stopped. This means that the machine has stopped/
paused all functions. Press the START button to turn the programmed settings of the
machine and the timer on and resume operation. Please follow the set up instructions to
reset or change to new desired settings.
5. SET button enables you to set the temperature and the time. If you press the SET button once, the
3 digit TEMP window will flash. If you press the SET button once more, the 2 digit TIMER window
will flash.
(1) Press the SET button once – While the TEMP window flashes, set the desired temperature by
using the 10 or 1 buttons to select your desired temperature. When the TEMP window displays
your desired temperature, press the SET button to finalize your temperature setting. Your desired
temperature is now set up, and the TIMER window will flash.
10
partment will be heated to, not the average temperature.
The actual temperature of the drying compartment may be affected by
changes in the temperature and humidity of the inflowing air, which may
result in slight temperature fluctuations.
the two heating coils is active at any given time.