Operation - Tribest Sedona SD-P9000 Manual De Instrucciones

For your safety and to protect your Sedona, please follow the instructions below.
1. Always keep the Sedona on a leveled surface.
• Keep the Sedona at least 10 cm away from other appliances or furniture.
2. Place food on each tray as the instruction manual book explains.
• Cut the food into even slices.
• Use one tray for each type of food. Do not place different types of food on one tray.
• Lay the food in rows on the food tray with at least a one inch gap in between each slice
of food so that each piece does not overlap onto the next.
• You may dehydrate up to 9 trays simultaneously.
• For 4-5 trays of dehydrated recipes, please use the upper compartment for best results.
3. Open the door to insert trays into the Sedona. Hold the tray in the horizontal position and push
the tray into the proper slots.
• Please double check whether all the trays are properly loaded.
4. Plug in to an outlet that has 10-amp capacity.
5. Turn the main switch ON.
6. Set the temperature and time. Press the START/PAUSE button.
• Please refer to Set-Up page.
• The Sedona will automatically switch to stand-by mode after the drying time has expired.
Also, an alert tone will sound when the drying time has expired.
• Turn the main switch OFF when done using the Dehydrator.
7. The Sedona is designed to evenly distribute warm air from the rear to the front of the unit.
Depending on the climate and temperature of the air flowing into the unit from the rear, there
may be a slight difference in temperature between the trays and inside the drying compartment.
Because heat rises naturally, it is normal for the top trays to be exposed to more heat than the
trays in the center or on the bottom. For best results, rotate the trays periodically.

OPeRaTIOn

9
EN