Picture Mode - Bresser 33-10100 Instrucciones De Uso

air outlet of a chimney or other heat sources to prevent
false triggering.
2. The height from ground for placing the camera should
vary with the object size appropriately. In general, one to
two meters are preferred.
3. Slide the power switch to the ON position to power
on the camera.
After switching the camera on, the unit will start, depend-
ing on the mode, to automatically record picture or video
after 60 seconds. These 60 seconds are intended as a
buffer for you to bring the camera in position.
3.4 Enter into the TEST MODE
In TEST mode, it is required to connect the control and
then to customize settings. Make sure the device is in
OFF mode when connecting the wired control with the
camera.
Note: When the camera is currently recording a picture
or video, this action will be shut down first. If you con-
nect the handbox during that time, the LCD Display will
illuminate white. Remove the handbox and connect the
handbox at a later time.
If this is displayed on the handbox, move the Main
switch to the position „ON".
Note: If the wired control is still connected to the cam-
era, the camera will not work!
3.4.1 Manual capturing
It is possible to to capture pictures when in Test Mode.
Move to the Picture mode via

Picture Mode

Simply press the key on your handbox to capture an
image.
GB
or .
29