Rockwell Automation Allen Bradley InView Serie Manual De Instalación página 9

8 InView Marquee Message Display
Mounting bracket
on the sign
Mounting
bracket on the
Alignment holes
wall
Lock
nuts
Publication 2706-IN006E-EN-P
8. Match the alignment holes of the brackets on the sign with the
alignment holes of the brackets on the wall so that the sign is at
the desired viewing angle.
TIP
9. Fasten the mounting brackets together using two 10-32 x 3/4
Phillips screws, two 10-32 washers, and two 10-32 lock nuts
through selected alignment holes on each end of the sign.
Torque to 2.7 Nm (24 in-lb).
10. Tighten the 5/16 nuts in the mounting holes. (See Step 7).
Washers Torque to 2.7 Nm (24 in-lb).
Phillips
screws
The second mounting bracket is shown here for
illustration only. It is actually mounted to the wall.