miniland baby digimonitor 7" Manual De Instrucciones página 18

· Turn OFF both the Intercom and the NEW Camera first. Place them not more than 2 feet
apart.
· Turn the Monitor ON. Press the MENU button (18) for 6 times to get into CHI CH2 CH3 CH4
SCAN on screen, and use Adjustment Control button (+ - ) (17) to choose the channel which
will be used in the new link. For example: choose channel 2; then press the Code button
(25). Then the displayed Channel 2 number will be blinking, it means Linking process on
Channel 2 is activated & get ready.
· Then Turn ON the NEW Camera. Press and hold the hidden SYNCHRONIZATION button
(10) through the small hole at the back of the Camera using a pin. The Power LED Light will
start flashing, indicating Synchronization process is activated. Remember the Intercom unit
must be ready as above mentioned.
· Linking is successful when your live image can be seen on the monitor screen.
At this moment, the channel 2 number on monitor screen and the power LED on the Camera
stop blinking. Now the new Camera unit and the Monitor unit are connected.
· If you wish to link more cameras, press the MENU button (18) for 6 times to get into Channel
Selection function again, and select Channel 3 or 4.
· Repeat the above process for 'PAIR' for additional cameras.