Installation Clearances; Dryer Dimensions - Maytag 3RMED4905TW0 Manual De Uso Y Cuidado

Installation Clearances

The location must be large enough to allow the dryer door to open fully.

Dryer Dimensions

27.9 cm
110.5 cm
(43 ½")
97.2 cm
(38¼")
*74.3 cm
(29 ¼")
A. Terminal block cover
B. Power supply cord/cable strain relief
*Most installations require a minimum 12.7 cm (5") clearance behind the dryer for the
exhaust vent with elbow. See "Venting Requirements."
Exhaust dimensions
35.9 cm
(14¹/₈")
A
A. Back exhaust
B. Left or right side exhaust
8
A
(11")
B
60.3 cm
(23³⁄₄")
68.6 cm
(27")
10.2 cm
10.8 cm
(4")
(4¼")
26 cm
(10¼")
B
Installation spacing for recessed area or closet installation
The following spacing dimensions are recommended for this dryer. This dryer has been tested
for spacing of 0 cm (0") clearance on the sides and rear. Recommended spacing should be
considered for the following reasons:
Additional spacing should be considered for ease of installation and servicing.
Additional clearances might be required for wall, door and floor moldings.
Additional spacing should be considered on all sides of the dryer to reduce noise transfer.
For closet installation, with a door, minimum ventilation openings in the top and bottom
of the door are required. Louvered doors with equivalent ventilation openings are
acceptable.
The dryer must not be installed behind a lockable door, a sliding door or a door with a
hinge on the opposite side to that of the dryer.
Companion appliance spacing should also be considered.
45.7 cm*
(18")
2.5 cm 68.6 cm 2.5 cm
(1") (27") (1")
A
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
*Additional spacing recommended
7.6 cm*
35.6 cm*
(14" max)
2
310 cm *
2
(48 in. )
2
24 cm *
2
(155 in. )
7.6 cm*
2.5 cm* 74.3 cm 12.7 cm
(1") (29¼") (5")
B C
(3")
(3")