Regarding Lithium-Ion Battery Transportation - HIKOKI С 3607DA Instrucciones De Manejo

English
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
○ If the BSL36B18 (sold separately) is installed in the
power tool, the power output will exceed 100 Wh and
the unit will be classifi ed as Dangerous Goods for freight
classifi cation.
Power Output
Wh
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (ONLY WITH
UC18YSL3 CHARGER)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS (Fig. 1 – Fig. 27)
Switch
1
Switch lock
2
Saw cover
3
Lower guard lever
4
M7 bolt
5
Washer (B)
6
Saw blade
7
Lower guard
8
Guide
9
Base
0
Inclined lever
!
Guide fastener wing-bolt
@
Inclined gauge
#
Handle
$
LED light
%
Lock lever
^
5 mm Hex. bar wrench
&
Battery
*
Lever
(
Square
)
Hex. socket set screw
q
3 mm Hex. bar wrench
w
Lock spring
e
Premarked line
r
Front scale at 45° incline
t
Front scale when not inclined
y
Mode selector switch
u
Silent mode indicator lamp
i
Battery level indicator switch
o
Battery level indicator lamp
p
Lighting mode switch
a
Lighting mode indicator lamp
s
Lever (short type)
d
Dust collector
f
M4 Screw
g
Washer (A)
h
12