Regarding Lithium-Ion Battery Transportation - HIKOKI CB 3612DA Instrucciones De Manejo

10. Do not immerse the battery or allow any fl uids to fl ow
inside. Conductive liquid ingress, such as water, can
cause damage resulting in fi re or explosion. Store your
battery in a cool, dry place, away from combustible and
fl ammable items. Corrosive gas atmospheres must be
avoided.
CAUTION
1. If liquid leaking from the battery gets into your eyes,
do not rub your eyes and wash them well with fresh
clean water such as tap water and contact a doctor
immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you fi nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the fi rst time, do not use and return it to your
supplier or vendor.
WARNING
If a conductive foreign matter enters in the terminal of lithium
ion battery, the battery may be shorted, causing fi re. When
storing the lithium ion battery, obey surely the rules of
following contents.
○ Do not place conductive debris, nail and wires such as
iron wire and copper wire in the storage case.
○ To prevent shorting from occurring, load the battery in
the tool or insert securely the battery cover for storing
until the ventilator is not seen.
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
Wh
2 to 3 digit number
NAMES OF PARTS (Fig. 1–Fig. 20)
Battery
Front handle
Dial for setting band saw blade circumferential
speed
Pulley guard (B)
Tension lever
Band saw blade
Guide plate
Duster plate
Pulley guard (A)
Handle
Switch
Switch lock
Housing
Motor (built-in)
Hook
Blade pulley cover (A)
Guide rollers
Blade pulley cover (B)
Hex. bar wrench
Pulley guard (C)
Name plate
LED light
Latch
Charge indicator lamp
M8 bolt
Bearing holder (B)
Loosen
Tighten
M6 fl at-head screw
Guide plate (normal working position)
Holder plate (A)
M8 hex-socket set screw
Blade pulley (A)
Blade pulley (B)
Direction of rotation
Bearing holder
Tab
Workpiece
Blade pulley rubber
Band saw blade back ball bearing support
11
English