General Requirements - Miller Edge FALL PROTECTION SYSTEM Manual De Operación Y Mantenimiento

I. GENERAL REQUIREMENTS
A. WARNINGS AND LIMITATIONS
Proper precautions should always be taken to remove any obstructions, debris and other
material from the work area that could cause injuries or interfere with the operation of the
system. Also, caution should be taken to ensure all equipment will be clear of all other
recognized hazards and proper ventilation has been provided in the work area before work
begins.
Note: Users should be familiar with pertinent regulations governing this equipment. All individuals
who use this product must be correctly instructed on how to use the system and must read and
understand the following instructions before using the system.
•
Only trained personnel should use this system and its components.
•
Do not use if the unit or any part of the system appears to be damaged.
•
Do not use the system if any components do not operate properly.
•
Use in highly corrosive or caustic environments dictates a more frequent
inspection and servicing program to ensure the integrity of the system is
maintained.
•
Do not attempt to repair this system.
•
Personal fall arrest systems and components subjected to impact loading shall be
immediately removed from service and shall not be used again for employee
protection until inspected and determined by a competent person to be
undamaged and suitable for reuse.
•
Employer must provide for prompt rescue in the event of a fall.
•
All equipment must be inspected before each use.
•
Any component exhibiting deformities, unusual wear, or deterioration must be
immediately discarded.
•
This product is designed for personal fall protection. Never use fall protection
equipment for purposes other than which it is designed.
•
Never use fall protection equipment for towing or hoisting.
•
Always check for obstructions below the work area to make certain the potential
fall path is clear.
•
Use only compatible locking snap hooks or locking carabiners with this product.
•
Use only approved Miller hardware with this product.
•
Do not attempt to move the unit while workers are attached.
•
Do not use unit on uneven or sloped surfaces greater than 5% from the horizontal.