Miller Edge FALL PROTECTION SYSTEM Manual De Operación Y Mantenimiento página 5

B . SYS EM COMPONENT INSTALLATION: T
Unit As sembly Overview:
Step 1. Install Vertical Boom Assembly.
Step 2. Install Push Pin and Hitch pin.
Step 3. Install Horizontal Boom Assemb
Step 4. Install Push Pin and Hitch pin.
Step 5. Inspect the installation and components of the unit before each use.
U nit Assembly Details:
NOTE: For safety and ease of assembly, it is recommended that two or more workers
a ssembly and installation of the system assemble the vertical and horizontal booms.
Vertical Boom Installation: Refer to fig. 2. for typical installation.
Fig. 2
H orizontal B oom Installation: Refer to fig. 3. for typical
installation.
Step 1. With the anchorage points facing the front of the
unit, place the Horizontal B
b oom as shown in fig. 3.
Step 2. Install the Push Pin through the horizontal boom
and ensure that the pin goes through both sides of the
Vertical Boom and exits out t
b oom. Install the Hitch Pin.
WARNING: Ensure that the Hitch Pin has been
installed thro ugh the Push Pin. DO NOT USE UNIT IF
H ITCH PIN IS MISSING.
D isassembly: Reverse above procedures.
ly.
Step 1. With the Lifting Ring facing toward the back end of
the unit, install the Vertical Boom down inside through the
handle box and d
shown in fig. 2.
Step 2. Install the Push Pin through the main body of the
unit and ensure that the pin goes through both sides of the
Vertical Boom and exits
body. Install the Hitch Pin.
WARNING: Ensure that the Hitch Pin has been
installed through the Pu
HITC
Disas
oom over the top of the vertical
he other side of the horizontal
own inside the main body at the location
out the other side of the main
sh Pin. DO NOT USE UNIT IF
H PIN IS MISSING.
sembly: Reverse above procedures.
Fig. 3
trained in the
Front