Installing The Manhandler Hoist - Miller Edge FALL PROTECTION SYSTEM Manual De Operación Y Mantenimiento

Installing the ManHandler Hoist

W hen standing behind Edge system the ManHandler can only
be installed on the left side of the 9081MRMB unit.
S tep 1. Place the ManHandler to the 9081MRMB at the location
shown and align the top holes. Ref. fig.
Step 2. Insert the both pins completely through both the bracket and
the tubing of the 9081MRMB.
Step 3. Open the pulley sheave by rotating half of the sheave. Pla
the cabl e on to the wheel of the pulley and
Step 4. Ensure that cable is over the steering handles of the Edge
unit and not under, attach the
connect to the anchorage
Disas sembly: Reverse above procedures.
Warning: Both pins must only be installed at location shown. Failu
to install pins at these locations could result in serious inju
Note: For operation and maintenance to
time of shipment.
9081WT/300LB Counter Weight Installation:
Step 1. Locate the installation holes in the gussets in front of the I-beam. Ref. fig. 8
Step 2. Install the plates with (4) spacers on each side between the bottom plate and gusset. Ref.
fig. 8
Step 3. Install a flat washer on the bolt, feed the bolt through the holes of each plate
the gusset as shown in fig. 8
Step 4. Install flat washer and hex nut. Tighten until snug then add 1/2 turn. Ref. fig. 8
Warnin g: All (4) counter weights must be installed. Failure to install all counter weights may result in
serious injury or death.
Warnin g: Counter weights must be used for units with anchorage points higher than 8 ft.To det
anchora g e height reference fig. 9
Note: Inspect for loose or damaged components prior to use. If any damage or loose hardware is
detecte d do not use system.
Fig. 8
Front of Unit
7
close the pulley sheave.
carabiner to the pulley sheave and
point. (Eyebolts) Ref. fig. 1
the ManHandler follow instructions supplied with the unit at the
ManHandler
ce
re
ry or death.
7/16" x 6" Bolt
7/16" Flat Washer
Cou nter Weights
Spacers
Gusset
7/16" Flat Washer
7/1 6" Hex N ut
Fig. 7
Unit
Front o
Bot
Installa
9081MRMB
and through
ermine
Fig. 9
Top
Installation
Hole
f Edg e
System
tom
tion
Hole