Miller Edge FALL PROTECTION SYSTEM Manual De Operación Y Mantenimiento página 8

L ifting the unit:
B efore attempting to lift the unit, inspect to ensure the hitch pins are securely installed to the push pins.
L ifting the unit is accomplished by using the Lifting Rings provided. Ref. fig. 1
WARNING: Attem pting to lift, raise or hoist the unit by using only one lifting ring or by using other
a reas of the unit is prohibited and may cause the unit to become unstable, unbalanced and cause
the unit to fall or tip over causing serious or fatal injury. Never use Anchor Points to lift, raise or
hoist the unit.
Warning: Do not use lifting rings for fall protection.
Installation Distance:
O nce the unit has been installed at the desired location, ensure the unit has been placed at a minimum of
(2) feet from the front of the unit to the leading edge of th
th e unit to the side edge of the work surface. Ref. fig. 10. WARNING: Do not use the system if installed
less than the required
s hould a fall occur.
W orking Distance:
The working distance is the maximum distance a user can work away from the system while anchored to
the unit. The maximum working distance forward, measuring from the vertical boom is 26 ft. The
maximum working distance from the side of the unit, measuring from the vertical boom is 12 ft. Ref. fig.10.
WARNING: DO NOT EXCEED WORKING DISTANCE REQUIREMENTS.
distance from the edge. Failure to do so may cause serious or fatal injury
Fig. 10
e work surface and (3) feet from either side of