Electrolux EFLS527UIW1 Instrucciones De Instalación página 14

14 Reversing Door
Reversing Door Assembly, continued
3. Make sure the alignment tabs reengage.
Connect to Notches
4. Reattach the inner door to the outer
door using the nine screws removed
earlier. See illustration, Step 1.
5. Check to verify that the
scoop (wider section) of
the door glass is situated
at the BOTTOM of the
door.
Reinstalling Door Assembly
1. Insert the wiring harness terminal into
the terminal cap and wrap the harness
into the harness retainer.
2. Slide terminal cap onto back of hinge
plate until tabs snap into place.
3. Insert hinge locating pins into the hole
that were previously covered by the
plastic hole cover. Press on the face
of the hinge to snap the other locating
pins into place.
4. Reinstall all four screws removed
earlier - two front screws first, then two
side screws.
x4
Fine Thread
2
Verify Reversed Door Operation
1. Test door for free, smooth swinging
operation and secure latching when
closed.
2. Verify inner door glass is in the correct
orientation with the "scoop" at the
bottom.
3. Plug in washer and close the door.
Test correct door lock operation by
starting a test cycle: lock should
engage, and door should not be able
to be opened until cycle is paused or
canceled.
1
3
4