Disposal Of Packaging Materials; Assembling The Appliance; Handling And Operation; Filling With Water - Silvercrest SDM 1500 C2 Instrucciones De Uso

Disposal of packaging materials

The packaging protects the appliance from damage during transport. The packaging
materials have been selected for their environmental friendliness and ease of
disposal, and are therefore recyclable.
Returning the packaging into the material cycle conserves raw materials and
reduces the amount of waste generated. Dispose of packaging materials that
are no longer needed in accordance with applicable local regulations.
NOTE
► If possible, keep the appliance's original packaging during the warranty
period so that the appliance can be packed properly for return shipment
in the event of a warranty claim.

Assembling the appliance

Push the main unit 3 onto the connection nozzle 4 on the steam foot 5 and
♦
press the main unit 3 down until the round catch clicks into place.
Attach a pad 6 from below onto the steam foot 5.
♦
NOTE
If you intend to clean carpeting with the steam mop, fi t the steam foot 5
►
onto the carpet ring p. Ensure that the carpet ring unlocking aid a is in
line with the connection nozzle 4. Push the steam foot 5 onto the carpet
ring p so that it clicks audibly into place. This will allow the pad 6 to
glide over the carpet.
To remove the carpet ring p, press your foot onto the carpet ring release
►
aid a and pull the steam foot 5 carefully off the carpet ring p.

Handling and operation

This section provides you with important information on handling and using the
appliance.

Filling with water

CAUTION – PROPERTY DAMAGE!
Never operate the appliance without water in the water tank 8!
►
The pump could overheat and be damaged!
1) Push the "Water tank" release button 9 downwards and simultaneously
pull the water tank 8 towards the rear and off the appliance with a tilt
movement.
2) Turn the water tank 8 and unscrew the cap.
3) Fill the water tank 8 with tap water up to the MAX mark.
│ GB │ IE
■ 26 SDM 1500 C2