Technical Specifications; Symbols - Stiga SEV 2416 Q Manual De Instrucciones

IDENTIFICATION OF MAIN COMPONENTS / SYMBOLS
Maximum noise and vibration levels [1]
Operator ear noise pressure level
– Measurement uncertainty
Measured sound power level
– Measurement uncertainty
Garanteed sound power level
Vibration level
– Measurement uncertaint

TECHNICAL SPECIFICATIONS

Voltage
Power frequency
Motor power
Bar length
Chain speed
Weight
Oil
[1]
Notice:
The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric equipment
as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indicated. Safety
measures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions.
In this regard, all the operational cycle phases must be taken into consideration, such as switching off or idle running.

2. SYMBOLS

1) Read the instruction manual before using the
machine.
2) 3) If you are using the machine every day in
normal conditions, you can be exposed to a noise
level of 85 dB (A) or higher. Wear safety glasses
and hearing protection.
EXPLANATORY SYMBOLS
ON THE MACHINE
(if present)
11) Direction in which the chain
is mounted
4) Do not leave the machine in the rain (or in
damp con ditions).
5) Unplug the chain-saw immediately if the ca ble
(or extension lead) is cut or damaged.
6) Maximum permitted length of the bar. Do not
use longer bars.
12) Direction in which the chain
runs
dB(A)
dB(A)
dB(A)
dB(A)
dB(A)
m/sec
2
m/sec
2
V~
Hz
W
mm / "
m/sec
kg
ml
13) Rotation direction to loosen
(a) or tighten (b) the bar
3
EN
84,92
3
104
3,01
107
3.838
1.5
220-240
50
2400
405 mm 16"
13.5
5.3
230