Nussbaum BM Touch Serie Manual De Instrucciones página 44

To measure wheel data move the inner gauge arm
to the desired position of the wheel weights that have
been set in the screen "balancing program"
Move the inner gauge arm (10) to the position and wait
for an audible signal. Then move the arm back to the
home position and an audible signal is heard.
ONLY BM 45 Touch and BM 55 Touch:
to the position and hold in place until an audible signal
is heard.
Replace the gauge back into its home position a long
audible signal is heard.
10
Input of wheel data in balancing program STEEL
10
Input of wheel data in balancing program ALU
for adhesive wheel weights (shown fort he left wheel weight)
The inner gauge arm is taken to input the DISTANCE
and DIAMETER, the outer gauge arm is used to input the
WIDTH.
44
As soon as the gauge arm is returned to ist home positi-
on the screen switches to the display of the wheel data
and the values are shown.
8
i
The values can be changed manually if required.
If you touch the area of a value a number field
shows up that allows to enter the data. The data
can also be changed by touching the + or - but-
ton.
025
Example of a manual data entry
026
12.08.2013 AD W9002 N
027
028