Data Input In Mode Pos; Starting A Balance Measurement Run; Placing Weights In Mode Standard (12H) - Nussbaum BM Touch Serie Manual De Instrucciones

4.4

Data input in Mode POS

The wheel balancer automatically detects that wheel
data are entered.
Is the wheel positioned in any other position that the „12
o´ clock position" and the gauge arm is moved from
its home position the balancer switches to „read wheel
data".
Is the wheel positioned in the „12 o´ clock position"
„place adhesive wheel weights with gauge arm" is ac-
tive. In order to read wheel data the wheel simply has to
be moved out of the „12 o´ clock position".
In Mode POS the following balancing programs are de-
tected automatically depending on the position the in-
ner gauge arm is attached to.
STEEL
POS
ALU 2
POS
ALU 3
POS
4.5

Starting a balance measurement run

Close the wheel guard and touch the START button.
i
Depending of the setting the balancing run is also
started automatically when the wheel guard is clo-
sed (see chapter 5.1.11).
Touching the Start button will start
the measuring run
The wheel will be braked automatically when the
measuring run is finished.
Depending on the setting of the brake (only BM 35 Touch,
BM 45 Touch and BM 55 Touch, see chapter 5.1.14 ) the
wheel will stop in the correction position, both arrows will
be green and the wheel is hold in position.
AD W9002 N 12.08.2013
4.6
!
LEFT CORRECTION PLANE
The wheel is positioned in the „12 o´ clock position"
shown by the green arrows.
Attach the weight by hand.
RIGHT CORRECTION PLANE
The wheel is positioned in the „12 o´ clock position"
shown by the green arrows.
Attach the weight by hand.
.

Placing weights in mode STANDARD (12h)

In Mode STANDARD (see chapter 5.1) the wheel
weights are ALWAYS placed by hand on the „12 o´
clock position".
Touch the POS button and the wheel is
turned automatically to the outer cor-
rection plane.
030
032
45