How To Use - Toto TBP01301 Manual De Operaciones

Llenador de bañera independiente (para cuerpo principal)
Ocultar thumbs Ver también para TBP01301:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
EN
A

How to Use

A-1
How to adjust the temperature
Cold water comes out if you turn the lever handle towards you. If you turn it
away from you, the water temperature rises gradually.
If you turn the lever handle fully to the side opposite to you, the water
temperature rises to the maximum.
When using hot water at high temperatures, do not directly touch the
spout and body.
You may get scalded.
A-2
Turn on the cold (hot) water
Move the lever handle to the right side.
Water comes out.
If you move it to the rightmost position, the flow rate becomes the
maximum.
To stop cold/hot water
Move the lever handle to the left side.
Water stops coming out.
Use the lever handle slowly.
In some cases, using the lever handle too forcefully causes water
hammering.
A-3
Diverter valve
Lift the diverter valve.
Water comes out from the shower.
However, if too little water comes out, water will not change to the shower.
If you want water to come from the spout after changing to water to come
from the shower, press down the diverter valve.
A small amount of water may come out from the spout during use of the
shower but it is not due to any problem.
Water drains from the showerhead for a while after the shower is
stopped.
This is to drain off the water remaining in the showerhead.
If it keeps draining for several minutes, check to see if the handle is
closed completely.
If you want to drain the remaining water manually, shake the showerhead
5 - 10 times.
31

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tbp02303

Tabla de contenido