Inserting/Exchanging Gobos - Futurelight PFE-1200 Manual Del Usuario

Procedure:
Step 1: Unscrew the housing screws and remove the housing cover.
Step 2: Loosen the knurled-head screws on both ends of the lamp.
Step 3: If replacing the lamp, remove the old lamp from the lamp holder.
Step 4: Insert the lamp into the lamp holder.
Step 5: Tighten the two knurled-head screws.
Step 6: Replace the housing cover and tighten the housing screws.

Inserting/Exchanging gobos

If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
When installing metal gobos, please make sure that the mirror-inverted side points to the lamp. When
installing glas-gobos, please make sure that the coated side points away from the lamp.
Do not operate this device with opened cover!
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
32/93 51837580_V_1_2.DOC