VERIGA ARKTIK Manual Del Usuario página 10

Warning against misuse:
Legal regulations require that these warnings are attached although many of
them will seem selfevident to you. But always keep in mind that these instruc-
tions have to be observed on any condition and that we will not assume liability
for any damage resulting, even in part, from the non-observance of these
instructions. By using the anti-skid-chains, you and your staff declare to have
taken notice of and will observe these warnings and that you will not assert
any claims against the manufacturer, importer or retailer in case of non-ob-
servance. Non-observance of the following instructions may cause substantial
damage to persons or property (road accidents) with severe consequences.
1. Anti-skid chains should only be used for mounting on vehicle tires. These
chains as well as the spare parts are case-hardened, thus being wear-resistant,
and must not be used for pulling, lifting or other purposes.
2. Only mount the chains on tires of the dimensions specified on the respec-
tive label of the package. Chains fit new tires corresponding to the ETRTO
standards mounted on adequate rims. Retreaded tires are often larger and
the perfect fit of the chains has to be checked in each case. Please consider
the recommendations of the vehicle manufacturer. If the chain does not fit
perfectly it must not be used. Check the inflation pressure according to the in-
structions of the vehicle manufacturer. The air pressure must not be reduced
before the mounting and then increased again as this could lead to damage
(breakage, cracks) of chain and tire due to overtension.
3. Check the chains before use. If parts of the chain are damaged or broken the
chain must not be used. Do not mount chains worn by more than one half of
the diameter of the wire, even if only one link is affected.
4. Chains must always be mounted in pairs on an axle.
5. Read the mounting instructions carefully. Non-observance of the mounting
instructions may result in malfunctions of the chains and damage to the car
and may increase the risk of accident.
6. Before using the car always check if the chains have been mounted correctly.
7. After a short driving distance (approx. 50 to 100 meters) the perfect and
centric fit of the chains has to be checked. Retension chains if necessary.
8. Tension the anti-skid-chains only as tight as necessary. Excessive tensioning
may cause damage to chain and tire.
9. Make sure that after the mounting no part of the chain grazes parts of the
vehicle.
10. On a surface completely covered with snow the driving speed should not
exceed 50 km/h; drive considerably slower if the road is partly free of snow.
Maximum Speed 50 km/h.
11. Avoid spinning of the chains. Increased wear would lead to greater damage
to the chain.
12. Check condition and wear of the chains during travel (at intervals of 20 km
or after longer periods of driving on roads free of snow).
13. Repairs of damaged chains and modifications to suit a different size should
only be carried out by qualified personnel.
14. Only use original spares for repairs.
10 |