10. Position the back panel against the back of the range, but do not fasten.
11. Gently, pull the excess power cord to the outside.
12. Position the lower part of the strain relief under the power cord and tighten the
strain relief screws.
NOTE: Before tightening, make sure the strain relief is positioned over the cord
and NOT the wires.
13. Replace the back panel screws, and then fully tighten the screws.
14. Plug range into grounded outlet.
15. Tuck excess power cord under the range.
POWER CORD - CANADA ONLY
Plug into a grounded outlet.
Do not use an extension cord.
Failure to do so can result in death, re, or electrical shock.
1. Plug into a standard 14-50R grounded wall receptacle.
2. Go to STEP 4 - INSTALL RANGE.
14
a
b
WARNING
Electrical Shock Hazard
a
Strain Relief
Screws
b
Lower Part of
Strain Relief