Location Requirements - Haier HCR2250AES Instrucciones De Instalación

Estufa independiente eléctrico de 24"
Ocultar thumbs Ver también para HCR2250AES:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PARTS SUPPLIED
Check that all parts are included.
a
NOTE: The Anti-tip bracket must be securely mounted to the subfloor. The
thickness of flooring may require longer screws to anchor bracket to subfloor.
Longer screws are available from your local hardware store.
PARTS NEEDED
If using a power supply cord:
A UL listed power supply cord kit marked for use with ranges. The cord should
be rated at 250 volts minimum, 40 amps or 50 amps that is marked for use
with nominal 13/8" (3.5 cm) diameter connection opening and must end in ring
terminals or open-end spade terminals with upturned ends.
A UL listed strain relief.
If direct wiring:
Flexible Metal Conduit
UL Listed Conduit Connector
4-Wire or 3-Wire Electrical Cable (where local codes permit a 3-wire connection).
UL Listed Wire Connectors
Check local codes. Check existing electrical supply. See the appropriate "Electrical
Requirements" section. It is recommended that all electrical connections be made
by a licensed, qualified electrical installer.

LOCATION REQUIREMENTS

VENTILATION
IMPORTANT: Observe all governing codes and ordinances.
It is the installer's responsibility to comply with installation clearances specified
on the model/serial rating plate. The model/serial rating plate is located on the
left-hand side of the oven frame. Open oven door to view label. See label on back
panel of range for additional element and oven power ratings.
a
b
b
16 x 15/8" Screws (2)
Anti-tip Bracket
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hcr2250acs

Tabla de contenido